Page 1 of 1

AW11 and SW20 A/C Factory Denso Installation Library

PostPosted: Thu Jun 14, 2018 3:37 pm
by entrax
This is for cars that do not have A/C and you want to install A/C in the car as they did back when the car was new. For US cars, this is done at the factory, but for Canadian cars, it was a dealer-installed accessory kit. The wiring diagram for the A/C system is also at the end of the PDF.

This is for the SW20
Note:
    -The only difference between the factory piece and the dealer-install kit is that the 2 long pipes under the middle of the car are one-piece for factory, and two-piece for the kit to let you install it without removing the handbrake brackets under the car. Since a US car is practically the only place to get A/C pieces nowadays out of part-outs, this part of the installation can vary as of course you'd need to move the handbrake brackets to fit the one-piece long pipes.
    -Highly recommend to get a R134a compressor from a 94+ if used.

This is for the AW11

Thank you to:
Normandy for the high-res scans
Allan @JPtoyota for finding this manual after I lost it in a pile of paper.

Re: MR2 A/C Installation Manual

PostPosted: Wed Jul 25, 2018 2:57 pm
by entrax
R134a official documents:

This is the early manual for R134a conversion:
https://drive.google.com/open?id=1K4wLy ... 33W1z7xYMO

This the later manual for R134a conversion:
https://drive.google.com/open?id=1A0M4- ... p751IrVrb1

Quick specs:

R12:
  • AW11
    Refrigerant: 800 +/- 50g (1.76 +/- 0.11lbs)
    Compressor Oil: ND-Oil6
    Drier: Silica Gel
  • SW20
    Refrigerant: 850 +/- 50g (1.88 +/- 0.11lbs)
    Compressor Oil: ND-Oil6
    Drier: Silica Gel

R134a:
  • AW11
    Refrigerant: 750 +/- 50g (1.65 +/- 0.11lbs)
    Compressor Oil: ND-Oil8 100cc
    Drier: Zeolite
  • SW20
    Refrigerant: 800 +/- 50g (1.76 +/- 0.11lbs)
    Compressor Oil: ND-Oil8 140cc
    Drier: Zeolite