FS: MR2Gear shift knob black/black

[Oteck]

selling a rare and discontinued mr2gear shift knob for Gary. this is black on black as seen on the far right. asking $60

[mparkis]

Is this still available? Will this fit an AW11? I noticed the SW20 and AW11 have different threads.

Mike

[immorality]

I noticed the SW20 and AW11 have different threads

Are you sure. My TRD knobs (both the ball and the tall one) fit on both my '85 & my '94, as well as my '93 Celica.

[mparkis]

I've tried my SW20 (has 93+ lever) shift knob on my 88 and my 88 has a much thicker thread. Can anyone else confirm?

Mike

[Oteck]

can't say but i do have a brand new 93+ lever for 28 bucks if it doens't fit. I still have it fyi

[mparkis]

check email

[macatak]

they should all be interchangeable.I've been swapping OEM/TRD knobs between '87,'89,'91 and '93 levers
you just have to be careful to get the threads started straight because
the OEM/TRD knobs all have a nylon/plastic insert that sometimes gets cross threaded which makes it feel
like they don't fit.
Try turning it counter-clockwise slowly without any pressure on the knob and you should feel it drop onto the threads
when it lines up. then it should spin onto the first few threads with virtually no effort before it begins to tighten up
If the insert itself has been cross threaded you can clean it up with a bottoming tap
( I think it's 10 x 1.25 but might be 12 x 1.25, can't remember offhand)

[mparkis]

I'll try again tonight.
Thanks

[mparkis]

I must have been real tired when I tried fitting the shift knob. I tried again and if screwed in. yikes
Sorry for the confusion.

[macatak]

let me know if this is still available

thx

[Oteck]

still available

[macatak]

pm'd

[NoLifeTilMetal]

pm'd as well if it wasnt scooped up by macatak yet.

[Oteck]

pm replied

[Oteck]

sold