British Columbia MR2 Owners Group

by **Memphis** » Mon Apr 16, 2012 6:34 pm

I got my new wheel but the new horn has two wires. But I don't know how to connect it to my car seeings how there is only one wire. I would love some help in this department.
Thanks guys

by **immorality** » Mon Apr 16, 2012 7:12 pm

Show us a pic? What hub are you using?

by **Memphis** » Tue Apr 17, 2012 9:46 am

I'm using a cheap ebay one until i can afford a more expensive one. I will post the picture when I can. Any Ideas though? Has any one done this?

by **dh4ever** » Tue Apr 17, 2012 1:51 pm

if its two wires, run one to the hub addapter and the other to the POS wire coming from the columb. the single wire grounds to the hub/steering shaft. test it out, plug one into the origional plug, and tap the other one to the centre bolt holding the hub on, while pressing the button. it should beep only when you press the button. my MOMO has a ring that comes out of the button that is suposed to ground to the hub, if that isnt an option, it has a screw slot for grounding it.

by **Memphis** » Wed Apr 18, 2012 7:54 am

Thanks dh4ever. I'll check that out when I get a chance.

British Columbia MR2 Owners Group

horn button

horn button

Re: horn button

Re: horn button

Re: horn button

Re: horn button

Who is online